Operation requirements and transmission mechanism of the burner of the stenter setting machine

The use of the burner of the stenter setting machine is high in accuracy, and multiple links are formed by the combination of links during operation The unit and the driving link have one end of the upper and lower flanges of the pin hole chain, and are arranged on the deep groove ball bearing and the upper and lower sides, the upper and lower dust caps are arranged between the chain links, and the outer surfaces of the top and bottom rings A cylindrical protrusion is provided on the upper part, and the cylindrical boss of the upper dust cover is provided with a hole for oblique lubrication, and the end lubrication hole corresponds to the deep groove ball bearing. The high wear of the adjustment chain of the burner of the stenter setting machine is mainly caused by multiple units connected by combination keys, and any link units are parallel and spaced apart from each other, and the upper flange and the lower flange are empty. The cavity is coupled to the chain, and the two ends of the upper and lower flanges are respectively provided with holes for chain pins. The chain includes an oil-free bearing and the holes are arranged concentrically. The free oil of the sleeve bearing is shrouded on the axis of the pin. A card slot is provided at the upper end, a threaded hole is provided at the center of the upper flange, and a pressure plate is arranged. The center of the pressure plate of the burner of the stenter setting machine has a through hole to the corresponding thread of the hole, the bolt is inserted into the through hole, the bolt is screwed into the threaded hole and the edge of the pressure plate is inserted into the card slot, because the burner of the stenter setting machine Each rail section includes the top plate of the rail and the lower plate of the rail. A part of the bottom rail is provided with a lower plate and a lower plate. The lower plate is arranged in parallel with the upper plate of the rail, and the friction plate is arranged on The inner side of the baffle is opposite to the track plate of the lower plate, there are chain links in the chain, and the chain links in the chain are fixedly connected to the slave sensor. Adjustable cooling fan for the burner of the stenter setting machine. The low-temperature burner has an upper air outlet, which is arranged at the lower part of the air outlet of the casing, and on the opposite side of the bottom air inlet, and the electric motor is installed on the opposite side of the air inlet At the same horizontal position, the output shaft extends into the housing to install the blades, and the air volume adjustment device, the air volume of the adjustment device, includes a fixed plate sliding plate and a transmission mechanism. Adjusting the center of the burner of the stenter setting machine, the two sides of the fabric are placed in the center, the feed port of the machine guides the configuration of the fabric at the exit, because the discharge port of the upper belt guide machine is against the cloth roll, the guide belt stenter setting The machine burner feeds into the fabric outlet facing the machine, the drive belt of the stenter setting machine's burner faces the roll cloth, the drive belt is embedded in the upper fabric, and the lower stenter setting machine's burner drive belt interweaves the fabric as a guide belt and stenter setting Machine burner guide belt. ! If you are interested in low temperature burners, please contact us for a quote!