How to debug the burner

How to debug the burner? Here is a brief introduction to you a few steps. 1. The burner is installed on the stove. During combustion debugging, if there is black smoke, gradually open the big damper; if there is white smoke (water vapor), gradually close the small damper; the best if the damper is small to smokeless. 2. After the burner burns normally, work for a few minutes and turn it off. Stop it for a few minutes and turn it on again to observe whether the ignition and combustion are normal. If there is no abnormal phenomenon after repeated several times, the adjustment of the burner is finished. If the alarm light is on after starting the burner, you need to wait at least 20 seconds before pressing the reset button again to restart. 3. If the flame length is very short and the color is red, close the adjusting damper at this time until the flame is slightly yellow with faint glare, its ignition power is strong and the flame length is moderate. 4. If the color of the flame is red, its ignition strength is poor, and the fire speed is low, at this time, adjust the damper to continue to open until the flame is slightly yellow and faintly dazzling, its ignition power is strong and the fire speed is moderate. can. 5. Before the burner is started, first slightly open the adjusting damper under the body (opening is 1/3 of the full opening), and then turn it on. When the flame is lit, carefully observe its color, flame power and spray The flame speed and other conditions. To If you are interested in gas oil burners, please contact us for a quote!