Pay attention to these contents during the operation of the burner of the stenter setting machine

Normally, in order to ensure the normal operation of the burner of the stenter setting machine, as a user, in addition to the operating skills In addition, the following should be noted at the same time:, Regarding the operating tension control of the burner of the stenter setting machine. Under normal circumstances, the feeding device of this equipment requires low tension. For example, in the process of stenting and setting of knitted fabrics, the steps of unwinding on the car, the installation of the expansion roll before the padding car, and the installation of the passive roll after the nip are all related to the tension of the fabric. Therefore, the weft straightening and centering device should be used reasonably, and each device should be carefully checked to ensure low tension. The burner of the textile equipment should be adjusted in time if necessary. Secondly, during the normal operation of the burner of the stenter setting machine, in order to keep the loop structure of the entire width of the fabric uniform to prevent problems such as edge deformation, it is necessary to keep the overfeed control between 20% and 40% . In addition, since the knitted fabric is in a relatively relaxed state before being dried or shaped, this process is the key to eliminating residual tension and reducing residual shrinkage. Therefore, while maintaining the normal operation of the burner of the stenter setting machine, it is also necessary to control the critical moisture content of the fabric. It is more suitable to use a steamer to feed dry fabric during stenter setting. This is because saturated steam is used to give humidity, and the low-temperature gas burner can ensure that the moisture content of the knitted fabric is more evenly distributed across the fabric surface in the longitudinal and transverse directions. In addition to knitted fabrics, the stenter burner equipment can also be used to process many different fabrics. During the whole process, for fabrics with different fiber compositions, the process conditions, such as temperature and vehicle speed, should be set reasonably. And in actual production, the implementation of relevant process regulations must also be considered. In short, during the operation of the burner equipment of the stenter setting machine, suitable process conditions should be set for different production conditions to ensure the setting effect. If you are interested in low temperature burners, please contact us for a quote!