The cleaning work and output power value of the burner of the stenter setting machine

After the fabric is processed by the burner of the stenter setting machine, introduce the guide cloth to the operating table, tear off the guide cloth, and click to enter The cloth master control button turns to red, and the upper needle protection entrance button is turned off to '0'. Start the second half of the machine, and stop when the cloth guide head reaches the cloth outfeeding roller, connect the cloth guide with the guide belt, turn off the cooling drum tension motor to '0' and start the second half of the machine until the cloth guide is completely out of the cloth rack and stop. Turn off the main cloth output control button to red, start the machine and let the chain run idly. The burner of the stenter setting machine hits the oven button to enter the heating system interface, set the heating temperature to 150 degrees, the circulating fan power is 50%, the exhaust fan is manually controlled and exhausted at 100% power, which can effectively remove the residual moisture in the oven. So as to play a role in maintaining the oven. Turn off the heating system after running for about 30 minutes, let the circulating fan and exhaust fan continue to run until the temperature in the oven drops below 100 degrees, and then turn off. Turn off the main control switch of the power supply of the power-off cabinet to 'OFF', the computer will automatically store the processing data and turn it off to clean the whole machine. Click the icon of the circulation fan of the burner of the stenter setting machine to enter the power setting window of the circulation fan, click the total button of the circulation fan to pop up a small window for the power setting of the circulation fan, click on the white bottom number box to pop up a numeric keypad, and enter the required output power Value, press confirm. For the burner of the stenter setting machine, click on the upper left corner or the upper right corner of the exhaust fan icon to enter the exhaust fan power setting window, click the manual control button and confirm, and click the number box on the white background to pop up the small numeric keyboard to enter the required value and confirm. If you click the automatic control button and confirm, the exhaust fan will automatically adjust the power of the exhaust fan. Click the digital box showing the temperature in the oven simulation icon to enter the heating window, click the heating total to set the heating temperature, or you can set the heating temperature of each oven separately. When the heating temperature is below 90 degrees, click the small fire icon to heat, and when the heating temperature is above 90 degrees, click the big fire icon to heat and confirm. Start the front part of the machine. After the cloth guide has passed the upper needle protection entrance, turn on the upper needle protection entrance button to '1', and stop when the cloth guide goes out of the oven and reaches the cloth overfeeding roller, and the cloth guide and the cloth guide belt of the cloth exit part Connected well. Click the general control button of the cloth discharging mechanism to green, turn on the motors of the cloth discharging part to '1' (except the cooling cylinder tension motor switch), restart the machine, introduce the cloth guide to the cloth discharging rack, and then stop. Turn on the switch of the cooling cylinder tension motor to '1'. ! If you are interested in low temperature burners, please contact us for a quote!