Operation and maintenance of the burner of the stenter setting machine

When we operate the burner of the stenter setting machine, we must abide by certain requirements, which will not only guarantee us The work can be carried out smoothly and the quality of processing can be guaranteed. In the process of shaping, we need to make appropriate adjustments according to the width of the processed product to make it meet the required specifications. Let us understand the specific content below. When the burner of the stenter setting machine is in operation, the staff needs to adjust the 'feeding speed' according to the size, thickness and embroidery density of the processed product. Under normal circumstances, when the guide cloth passes through the heating area, the guide cloth needs to be inserted into the cloth rolling device. Note that the quality of the product should be checked at this time, and timely feedback should be given. If it is inappropriate, make adjustments in time. When the finalizing work is over, the heating switch of the equipment should be turned off ten minutes in advance. Afterwards, adjust its operation to a low-speed operation state, and then need to wait until the temperature of the burner equipment of the stenter setting machine drops to about 80°C before turning off the main power supply. The low-temperature gas burner needs to pay attention to that, when the equipment has been working for 60 hours, the covers on both sides of the heating compartment should be opened, the transmission parts should be checked and cleaned, and lubricating oil should be added according to the situation. When the working time of the burner of the stenter setting machine is over one hundred hours, the staff need to carefully check the wires, circuits, heating pipes and connection parts for damage, aging or looseness, and deal with them in time. Since this equipment is an electric heating device, in order to ensure safety when shaping chemical fiber fabrics, reliable grounding should be ensured. Later, I need to remind everyone that when the burner of the stenter setting machine is in working condition, the staff are not allowed to repair and inspect at will, so as to avoid scalding. Moreover, operators are not allowed to work with long hair, shirtless shirts, skirts, and gloves. In addition, it should be noted that no flammable and explosive hazardous materials should be stored around the equipment to avoid danger. If you are interested in low temperature burners, please contact us for a quote!