Several aspects of the safe operation process of methanol burners

Several aspects of the safe operation process of methanol burner 1. The inspection before the commissioning of the gas burner includes three aspects: a. Check whether the gas is in place, whether the gas pipeline is clean and unobstructed, and whether the valve is open. b. Whether there is pipeline leakage and whether the pipeline installation is reasonable. c. Bleed air from the pipeline before the gas valve to ensure that there is no mixed air in the pipeline, and the exhaust pipe should be connected to the outdoors. 2. Internal inspection of gas burner burner a. Whether the combustion head of the burner is installed and adjusted properly. b. Whether the direction of motor rotation is correct. c. Whether the external circuit connection meets the requirements. d. Perform a cold simulation of the burner according to the line conditions, and observe whether the various parts of the equipment are normal and whether the flame detection protection part is normal. 3. Debugging of gas burner burner a. Check whether the external gas is in place, the pipeline is unobstructed, and the external power supply is in place. b. Adjust the load of the burner to a small load, and adjust the ignition position to a small load accordingly. Turn off the large load to ignite and observe the flame condition. Adjust the servo motor or the air valve and gas valve group according to the flame condition. c. When adjusting the high fire output of the burner, it is necessary to gradually adjust from a relatively small load to a large load according to the load of the heating equipment, and adjust the servo motor or the damper accordingly. d. Observe whether the flame has partial fire, insufficient flame burning, vibration and other phenomena. e. After adjustment, ignition should be performed several times to observe whether the ignition is good. To If you are interested in gas oil burners, please contact us for a quote!