The principle of the burner of the high temperature stenter setting machine and some questions about the burner of the setting machine

The burner of the high temperature stenter setting machine, its How does it work? And, are there any other questions about this kind of setting machine burner that we don’t know and are familiar with? The specific reasons for why these problems are raised are to solve them thoroughly, so as to increase the amount of knowledge in this area and to gain new gains from them. 1. The working principle of the burner of the high-temperature stenter setting machine and the working principle of the burner of the high-temperature stenter setting machine are as follows: Unshaped cloth is fed into the burner of the setting machine through the stripper open width, at the same time, Both ends of the fabric are automatically hung on the needle plate, so that the needle plate can be brought into the oven with the stride, and the fan blows air at the same time. After that, after several hours of continuous operation, the cloth will enter the end of the equipment to cool down and remove static electricity. Then, the swing falls into the cloth car. Thus, a beautiful and smooth cloth can be obtained. The burner of the high-temperature stenter setting machine mainly includes the feeding part, the weft yarn device, the chain, the oven body and the doffing device. If necessary, there can also be a chemical material system and an oil furnace heating system. 2. Can the burner of the stenter setting machine determine the width of the knitted fabric? Can it adjust the shrinkage of the fabric? The burner of the stenter setting machine cannot determine the width of the knitted fabric. Because it is determined by the size of the equipment used when weaving, and has nothing to do with the burner of the setting machine. As for the shrinkage rate of the fabric, the burner of the setting machine can only be fine-tuned, not greatly adjusted. 3. What does the stenter finishing in the burner of the stenter setting machine specifically refer to? And, what is the difference between the burner of the setting machine and the stenter? The stenter setting in the burner of the stenter setting machine, in specific terms, refers to a more fabric state, appropriate drying adjustments, etc., until the shape is stable and the desired effect is achieved. The specific differences between the stenter and the burner of the setting machine are mainly in the three aspects of temperature, amplitude and requirements for fabrics. Therefore, these two are not common, and their common parts are very small. The origin of the burner properties of the velvet setting machine and the solution to the problem of elastic edge
The outstanding advantages of the burner of the stenter setting machine and the doubt on the amplitude modulation screw! If you are interested in low-temperature textile burners, please ask us for prices!