Burner manufacturers use high-temperature gas direct combustion technology

To Burner manufacturers refer to the use of straw and other agricultural and forestry wastes as fuels, using a semi-gasification combustion method, which effectively avoids the problem of straw particles slagging in the direct combustion process, and accurately controls the air distribution and progress. One machine can realize material, gasification and combustion, efficient and clean combustion. Burner manufacturers can directly output high-temperature flames and flue gas, and can be used directly with energy-consuming equipment such as boilers and industrial furnaces. The built-in parameters cannot be changed at will, otherwise an abnormal situation will occur. If you need to change the built-in parameters, please contact the biomass burner manufacturer. After using fire detection holes and detection holes, you must strictly follow the regulations. If this operation is violated, accidents are likely to occur, such as causing a fire. Therefore, it is necessary to equip the working environment of the burner with appropriate fire prevention facilities to ensure safe use. The diameter of the fuel used is controlled within 6-10mm. In addition, it is impossible to add dyes with more impurities or larger particles. When feeding, be careful not to add iron nuggets and other substances into the water tank, otherwise it will cause a biomass burner. Wood pellets or straw pellets biomass fuel; Boiling semi-gasification combustion and tangential vortex distribution design to complete the fuel and combustion; The equipment will not backfire and extinguish during low pressure operation, and the thermal load can be adjusted in a wide range of the combustion load of the burner It can be adjusted quickly within the range of 30%-120% of the rated load, and the starting block is sensitive; the pollution-free environmental benefits are obvious: the sustainable use of energy is achieved by using renewable biomass as fuel. Low-temperature staged combustion technology, low emission of nitrogen oxides, sulfur dioxide, dust, etc. in the flue gas is a substitute for coal-fired furnaces; Discharge of non-tar, waste water and other wastes: Using high-temperature gas direct combustion technology, tar is directly burned in the form of gas, which solves the technical problem of high tar content in biomass gasification and avoids water pollution caused by washing tar; easy to operate, Easy to maintain: automatic feeding, dust removal, simple operation, less workload, single duty; low investment, low operating cost: reasonable design of biomass combustion structure, low cost for various boilers. The built-in parameters cannot be changed at will, otherwise an abnormal situation will occur. If you need to change the built-in parameters, please contact the biomass burner manufacturer. After using fire detection holes and detection holes, you must strictly follow the regulations. If this operation is violated, accidents are likely to occur, such as causing a fire. Therefore, it is necessary to equip the working environment of burner manufacturers with appropriate fire prevention facilities to ensure safe use. The diameter of the fuel used is controlled within 6-10mm. In addition, it is impossible to add dyes with more impurities or larger particles. When feeding, be careful not to add iron nuggets and other substances into the water tank, otherwise it will cause a biomass burner. To If you are interested in gas oil burners, please contact us for a quote!