Before starting the burner, check to make sure that the connection of the burner and its components is firm

To Burners are also called burners. According to the fuel, they can be pided into oil burners, gas burners, and biomass burners; according to the objects of use, they can be pided into kiln burners and boiler burners; according to application fields, they can be pided into industrial burners, Civil burners and special burners. Among them, oil burners are pided into light oil (such as diesel) and heavy oil burners (such as waste oil). Gas burners are pided into natural gas burners, liquefied gas burners, city gas burners, biogas burners, etc., biomass burners It uses biomass particles to burn without dust and pollution. The burner we usually refer to refers to the boiler burner. 　　 The main application fuel types of the burner: 　 Fuel oil: light oil (only including diesel and kerosene), heavy oil, residual oil, etc.　Solid fuel: biomass pellets, sawdust, wood chips, wood flour, etc.　Gas: natural gas, artificial gas, liquefied petroleum gas, gas (coalbed gas), biogas, methanol and other six categories. Among them, the composition and calorific value of artificial gas, such as city gas, methane gas and biogas, are quite different due to raw materials and generation methods. To 　　 Operating procedures of the burner 　　 1. Before starting the burner, check to make sure that the connection of the burner and its components is firm, not loose, and the position remains unchanged. 　　 2. Ensure that there is no oil leakage from the fuel container to the combustion engine oil path and pipe fittings; the power supply is normal. 　　 3. Turn on the oil circuit switch and the power switch, the burner enters the self-checking state. After the self-checking is completed in about 30 seconds, the burner fan motor starts, and sparks are generated between the ignition power. After about 13 seconds of pre-blowing, a section of the kerosene pump motor Start, the oil pump solenoid valve is automatically opened, the oil mist sprayed from the injector is ignited by the electric spark to form a flame, the first stage of the fire burns normally, the ignition is delayed for about 10 seconds, and the ignition stops, the second stage fuel pump motor starts, and the oil pump solenoid valve It turns on automatically, the second stage fire starts to burn, the flame detector (electric eye) senses the flame brightness, the controller enters the locked state, and the burner enters the normal working state. 　　 4. After the burner is used or needs to be shut down, cut off the power supply and close the oil valve. To If you are interested in gas oil burners, please contact us for a quote!