Introduction to maintenance knowledge of stenter setting machine burners

Under normal circumstances, every time the burner equipment of the stenter setting machine runs for a period of time, it needs to be lubricated and maintained. At the same time, due to the different lengths of running time, the specific measures taken are also different. Generally speaking, when the burner equipment of the stenter setting machine has been running for 60 hours, the staff needs to open the covers on both sides of the heating chamber to clean and lubricate the mechanical transmission parts. Among them, it mainly refers to cleaning the main chain and gears of the burner equipment of the tenter setting machine, and then lubricating the running parts such as the gear shaft. When the working time of the equipment is over one hundred hours, the staff need to open the covers on both sides of the heating compartment to perform inspection operations, mainly to check the specific conditions of the wires, circuits, heating pipes and connections. If during the inspection, it is found that there are problems such as damage, aging or looseness, it should be dealt with in time. In addition, since the burner equipment of the stenter setting machine is an electric heating device, high static electricity may be generated due to the influence of factors such as environment, air and humidity when processing chemical fiber fabrics. To ensure safety, a reliable grounding wire should be installed on the body. At the same time, it should be noted that the diameter of the ground wire must not be 3 square millimeters. In addition, during the operation of the burner equipment of the stenter setting machine, repairs or inspections are not allowed to prevent burns. In addition, please note that it is strictly forbidden for operators to work with long hair, shirtless shirts, wearing skirts, and gloves. Later, I would like to remind everyone that you need to pay attention to checking the temperature of the burner equipment of the stenter setting machine during daily work. If the temperature exceeds 240°C, it may cause an open flame. Natural gas textile burners must not place flammable and explosive materials around the burner equipment of the stenter setting machine, and prepare relevant fire extinguishing tools. If you are interested in low temperature burners, please contact us for a quote!