Solution to the problem of running side of the burner of the stenter setting machine

We know that once the burner of the stenter setting machine runs sideways, the consequences are often very serious of. Therefore, after finding out the specific cause, we must deal with it immediately to avoid more serious consequences. So, how to control it? First of all, when we operate the burner of the stenter setting machine, we should pay attention to the operating status of the equipment. During the operation of the burner of the stenter setting machine, the stacking state of the cloth waiting to be processed should be checked and adjusted in advance to ensure the stacking adjustment. In this way, the low-temperature burner can also ensure its The smoothness. Secondly, the staff should also adjust the distance between the door width and the edge suction device according to the actual processing situation, and also adjust the pressure of the door. The third point is that when inspecting fabrics, defective fabrics should be selected in advance, so as to prevent running edges due to rotten edges. Fourth, we also need to install a baffle or a ruler wheel on the crossbar at the cloth inlet end of the burner of the stenter setting machine, which can reduce the lateral variation of the cloth surface, and at the same time, it can swing from side to side to avoid running sideways. . Fifth, the staff should operate the burner of the stenter setting machine correctly and try to ensure its stable operation. In addition, it is necessary to appropriately adjust the tension of the machine according to the tightness of the fabric structure. Remember, you can't use too much tension, otherwise there will be rotten edges or running edges. If the equipment is equipped with an overfeeding device at the same time, care should be taken to control the overfeeding so as not to lose the needle and cause running sideways. During the operation of the burner of the stenter setting machine, we also need to pay attention to the surrounding environmental conditions. For example, a larger screen can be used to solve the problem of gusty wind interference. At the same time, the equipment should be checked and maintained regularly, and damaged parts should be replaced in time. ! If you are interested in low temperature burners, please contact us for a quote!