The setting time and process conditions of the burner of the stenter setting machine

The stenter setting machine burner is to the extent that the original wrinkles are eliminated after the fabric is heat-set, and the surface is smooth The improvement of the fabric's dimensional thermal stability and other wearing properties are closely related to the level of heat setting temperature. The setting time of the burner of the stenter setting machine is another main process condition for heat setting. After the fabric enters the heating zone, the time required for heating and setting can be roughly pided into the following parts: 1. Heating time: After the fabric enters the heating zone, the time required to heat the fabric surface to the setting temperature. 2. Heat penetration time: After the fabric surface reaches the setting temperature, the fibers inside and outside the fabric have the same heat penetration time required for the setting temperature. 3. Molecule adjustment time: After the fabric reaches the setting temperature, the time required for the molecules in the fiber to adjust according to the setting conditions. 4. Cooling time: The time it takes for the fabric to leave the drying room to fix the size of the fabric for cooling. The setting time usually referred to by the burner of a stenter setting machine usually refers to the time required for the first three items, excluding the fourth item. If one item is regarded as a kind of preheating effect, then the setting time only refers to the time required for the second and third items, that is, the time required for thermal penetration and molecular adjustment. The time required for heating and heat penetration depends on the performance of the heat source, the weight per unit area of ​​the fabric, the thermal conductivity of the fiber and the moisture content of the fabric. The tension of the fabric during the heat setting process of the burner of the stenter setting machine has a certain effect on the setting quality, including the dimensional thermal stability, strength and breaking elongation of the fabric. The warp dimensional thermal stability increases with the increase of the warp overfeed during setting, while the weft dimensional thermal stability decreases with the increase of the degree of stretching of the door width. The average single yarn strength of the finalized fabric is slightly higher than that of the unshaped one, and the change in the weft direction is more obvious than that in the warp direction. After setting the fabric's breaking elongation, the weft direction decreases as the extension degree increases, while the warp direction increases as the overfeed increases. ! If you are interested in low temperature burners, please contact us for a quote!