There is already combustible gas in the furnace of the biomass burner, please remember not to open the furnace door

To When the feed rate of the biomass burner is too high, fluff is generated, and combustible gas is generated due to incomplete combustion. In this case, the feed frequency should be reduced to prevent accumulation and complete combustion of the fuel in the furnace. The air volume reduces the internal pressure of the furnace and the production of flammable gas. Increasing the air volume under the furnace and grate of the biomass burner, although the internal pressure of the furnace is slightly increased, the combustion of combustible gas can be greatly reduced, and it can be adjusted according to the conditions of the furnace. Burning flame during adjustment. Of course, it is also possible that the biomass burner is too much to ignite when it is ignited, so the feed must be controlled. If there is already flammable gas in the furnace of the biomass burner, remember not to open the furnace door. Before opening the furnace door, be sure to turn on the blower to blow out combustible gas. Otherwise, it is easy to cause a gas explosion, and it is safe for personnel and equipment. create a threat. Therefore, in a limited space such as a biomass burner, when the concentration of combustible gas reaches 5%-15% of the air share, the wine bottle will suddenly detonate the combustible gas in the limited space, which constitutes equipment and personal safety. The built-in parameters of the biomass burner cannot be changed at will, otherwise an abnormality will occur. If you need to change the built-in parameters, please contact the biomass burner manufacturer. After using fire detection holes and detection holes, please strictly follow the regulations. If this operation is violated, accidents are likely to occur, such as causing a fire. Therefore, the working environment of the biomass burner is equipped with appropriate fire prevention facilities to ensure its use. The diameter of the fuel used is controlled at 6 to 10 mm. Moreover, it is impossible to add dyes with more impurities or larger particles. When feeding, be careful not to add iron and other substances in the tank, otherwise it will damage the biomass burner. To If you are interested in gas oil burners, please contact us for a quote!