Precautions for burner debugging and maintenance

To 　　 has the following points: 　　 1. When the burner fails to re-ignite continuously, it should be shut down to check whether the air supply system of the Belden burner is normal and whether the circuit connection is correct. After the failure is removed, the burner can be restarted. 　　 2. It is strictly forbidden to knock or rub the gas supply pipeline with a wrench or metal rod to avoid static electricity or sparks, which may cause a gas explosion. 　　 3. Smoking, welding, cutting and other illegal operations are strictly prohibited in the air supply valve group or pipe flange surface. 　　 4. It is strictly forbidden to conduct any open flame test near the pipeline, valve block and pressure regulating valve to avoid major accidents. 　　 5. Test whether there is fuel in the gas supply pipeline, usually with a gas low pressure meter. 　　 6. In the gas supply pipeline, it has been evacuated, but there is residual gas or liquid droplets on the pipe wall. The debugging of the burner will also cause combustion and explosion if it encounters static sparks and open flames. 7. When the gas supply pipeline has been ventilated and the valve group is faulty, it needs to be disassembled. First, the front main valve of the valve group must be cut off, and then the gas in the pipeline from the main valve to the valve group can be vented, and then the valve group can be disassembled and removed. service. 　　 8. In the debugging work, gas must be serious, safe and efficient. 　　 9. It is prohibited to use non-explosion-proof electric power tools on site. 　　 11.600kcal and above burners are recommended to use VPS504 leak detection device, if the user does not match, the customer is responsible for the accident caused by it. 　　 The above are the precautions for the burner. If you have any other questions, please contact us in time. To If you are interested in gas oil burners, please contact us for a quote!