Solutions to the phenomenon of blocking and stuck materials in the burner

To If the burner appears to block or jam, use a wooden stick to poke it (usually caused by too long particles). Never use iron wire or steel bars to prevent the screw from being caught in the screw and causing damage to the screw; the fuel burns In order to ensure the safety and normal operation of the biomass burner, it is necessary to operate according to the following operating methods: 　　 1. Before starting the burner, clean the carbon deposits in the furnace bridge, clean the carbon deposits at the bottom of the furnace, add particulate fuel, close the tank cover, and open the material trap valve; 　　 2. Turn on the power of the equipment to be used, check whether the circuit and water pipe are normal, and the solution to the material jam phenomenon. Check whether the cooling pool has enough water. Solution to the jam phenomenon: Open the cooling water inlet and outlet valves of the burner, and the burner appears to block the material and confirm that the interlayer cooling water in the high-temperature combustion chamber is full; 3. Adjust the air supply gear to a lower position, put in an appropriate amount of base material, and start the oil (such as diesel) and heavy oil burner (such as waste oil). Open the furnace door lightly to supply air, close the furnace door, and start the feeding system , Gradually adjust the air supply gear to the right amount. When the burner appears to block the material, the feeding speed and the air flow rate should be gradually increased, and it is not advisable to accelerate too fast, so that the furnace temperature rises normally. 　　 The main application fuel types of the burner: Fuel oil: light oil (only including diesel and kerosene), heavy oil, residual oil, etc. Solid fuel: biomass pellets, sawdust, gas: natural gas, artificial gas, liquefied petroleum gas, gas (coal bed gas), biogas, methanol and other six categories. Among them, the composition and calorific value of artificial gas, such as city gas, methane gas and biogas, are quite different due to raw materials and generation methods. To If you are interested in gas oil burners, please contact us for a quote!