Precautions for the use of biomass burners

To For a long-term high-temperature operation equipment, the daily maintenance and maintenance of the biomass burner is very important. The biomass burner supplies heat to the entire production line. If the biomass burner shuts down due to a failure, the production line will also be shut down. Therefore, it is very important to do a good job in the daily maintenance and maintenance of biomass burners, reduce the failure rate of biomass burners, improve its performance reliability, and increase the efficiency of processing and production virtually, bringing benefits to enterprises. \t Precautions: 　　 1. Before use, pay attention to clean the ashes in the furnace, and keep the furnace dry without dampness and water accumulation. 　　 2. The debris and ash in the combustion tank must be cleaned up, and the silo cover must be covered after adding the material. 　　 3. When the new machine is used for the first time, there will be a small amount of pungent smoke (produced by the volatilization of anti-rust oil in the sheet metal and the paint on the machine), which will automatically disappear after a period of burning. 　　 4. Do not open the ash cleaning door when the machine is burning normally, it will leak air and affect normal burning after opening. 　　 5. When the machine starts to burn, it must burn in gear 1 or 2 for 5-10 minutes before it can increase gear to burn. 6. Please select the appropriate gear for combustion. If there is carbon exit from the fire outlet after burning for a period of time, it means that too much material is fed and it is caused by incomplete combustion; it is recommended to reduce the combustion by one gear (the gears are different when the particle material and density are different. ), or check whether the oxygen supplement hole is blocked. 　　 7. During the combustion process, there should be no shortage of material in the hopper (there will be smoke back if there is no material). And during combustion, no water can flow into the silo, no metal parts or other lumps can fall into it. 　　 8. When the machine is working normally, the temperature next to the fire outlet is high, do not touch it to avoid burns. 　　 9. Precautions for use Before each use, it is required to use a wire brush to clean the ash and impurities in the furnace. Do not use damp particles to avoid affecting the combustion effect 　　 10. Use a special tool to pull out the unburned particles after shutting down. 　　 11. The power must be cut off during cleaning and maintenance, and it cannot be directly washed with water. To If you are interested in gas oil burners, please contact us for a quote!