Several issues that need attention in the use of stenter setting machine burners

Under normal circumstances, it is not possible to make the stenter setting machine burner equipment work on the same type of door frame for a long time continuity , But should be replaced with different types of door widths at regular intervals. This prevents premature wear of the spline spindle. In daily work, the operator also needs to frequently check whether the various travel switches of the burner equipment of the stenter setting machine are sensitive and effective. If any damage is found during the inspection, it should be replaced in time. The amplitude modulation screw inside the drying room of the burner equipment of the stenter setting machine also needs to be cleaned frequently, generally once a month. If the equipment used is of the oil heating type, the filter on the heat-carrying oil pipeline should be removed for cleaning at least every six months. You can continue to use it after cleaning up. If you find that the oil pressure has dropped or the temperature has risen slowly during the daily use of the burner equipment of the stenter setting machine, it may be due to the clogging of the filter, which should be checked and handled in time. If it is electric heating, you need to check whether the electric heating tube has abnormal problems. If the current does not flow, it should be replaced in time. Normally, when the burner equipment of the tenter setting machine has been used continuously for seven days, the filter should be cleaned to remove the attached fluff. In addition, the hot air circulation system should also be cleaned regularly, especially the spray pipe needs to be cleaned once a month. As for the exhaust fan and exhaust ducts, they are generally inspected and cleaned every 3 to 6 months to avoid accidents. In addition to the content described above, the needle clips and needle plates of the burner equipment of the stenter setting machine should also be cleaned regularly, usually once a week. The low-temperature burner also needs to clean the oil in the oil pan above the exhaust duct once a week. ! If you are interested in low temperature burners, please contact us for a quote!