The heating system and precautions of the burner of the stenter setting machine

Press the reset button on the operation panel of the burner of the stenter setting machine, the indicator will go out, and the indicator will flash when the power is on. Press down the start indicator, the chain rotates, and the acceleration indicator flashes. Click the oven button for the burner of the stenter setting machine to enter the heating system 1. Click the burner of the stenter setting machine to enter the power setting window of the circulating fan, click the total button of the circulating fan to pop up a small window for setting the power of the circulating fan, click on the white bottom The numeric keypad pops up in the numeric box, enter the required output power value, and press OK. 2. For the burner of the stenter setting machine, click the exhaust fan in the upper left corner or the upper right corner to enter the exhaust fan power setting window, click the manual control button and confirm, click the number box on the white background to pop up the small numeric keyboard to enter the required value and confirm. If you click the automatic control button and confirm, the exhaust fan will automatically adjust the power of the exhaust fan. To a certain extent, the burner of the stenter setting machine needs to click the digital box showing the temperature in the oven simulation icon to enter the heating window, click the heating total to set the heating temperature, or you can set the heating temperature of each oven separately. If the heating temperature of the gas low-temperature burner is below 90 degrees, click the small fire icon to heat, and when the heating temperature is above 90 degrees, click the big fire icon to heat and confirm. Correct the cloth threading route, pass the cloth feeding part and guide the cloth (from the cloth feeding frame to the operating table), and follow the correct cloth threading route to pass the cloth outlet guide belt (from the cloth overfeeding roller to the cloth outlet frame). Press the red stop button on the operation panel, the chain stops, and the start indicator flashes. Pull the guide cloth onto the tentering chain and press the overfeeding wheel push button for about 10 seconds, and wait for the push button indicator to light up. The low-temperature burner turns on the motors of all parts of the cloth feeding mechanism to '1'. Raise the pour chute, apply the pressure of the rolling car, turn on the motors of all parts of the operating table (except the needle protection entrance button), and click the cloth feed control button in the upper left corner of the cloth feed mechanism to green. ! If you are interested in low temperature burners, please contact us for a quote!