Do you know how to debug the burner

To 　　 How to debug the burner? Here is a brief introduction to you a few key points. 　　 1. Installed on the stove, when burning and debugging, if there is black smoke, gradually open the big damper; if there is white smoke (water vapor), gradually close the small damper; the best is if the damper is small or smokeless. 2. After the combustion is normal, work for a few minutes to turn off the power, stop for a few minutes and turn it on again to observe whether the ignition and combustion are normal. If the alarm light is on after starting, you need to wait at least 20 seconds later, and then press the reset button again. start up. 　　 3. If the flame length is very short and the color is red, turn the adjusting damper down at this time. You know the burner until the flame is slightly yellow and faintly dazzling, its ignition power is strong and the flame length is moderate. 4. If the color of the flame is red, its fire strength is poor, and the fire speed is low, at this time, adjust the air door to continue to open until the flame is slightly yellow and faintly dazzling, its fire is strong and powerful, how to debug it? The fire speed is moderate. 5. Before the burner is started, first slightly open the adjusting damper under the body (opening is 1/3 of the full opening), and then turn it on. When the flame is lit, carefully observe its color, flame power and spray The flame speed and other conditions. 　　 The burner needs to be debugged through the above 5 steps, have you learned it? To If you are interested in gas oil burners, please contact us for a quote!