Introduction to the cloth feeding operation of the burner of the stenter setting machine

I wonder if everyone has mastered the cloth feed operation of the burner of the stenter setting machine? Although this operation is relatively simple, the problems that need attention are trivial, and this operation will affect the subsequent processing effect of the burner of the stenter setting machine. So as users, we also need to pay attention to this part of the content. That is to say, in actual work, we must wear the guide cloth in accordance with the requirements and check the worn guide cloth to ensure that it is correct. Then we need to clean the burner of the stenter setting machine first, especially to check whether there is dirt on the cloth feed frame and the front of the machine, and clean it in time. In addition, the textile burner needs to check for debris on the needle clamp and clean it up. In addition, the on-site environment should be kept clean and hygienic. After the inspection work is completed, we need to classify the fabrics to be produced according to the process conditions, and generally process the fabrics with the same technology. Then you should check the process card and verify that it is correct. According to the processing requirements of different fabrics, the cloth feed tension of the burner of the stenter setting machine, the width of the weft detection and the width of the stenter should be adjusted appropriately. In the process of operating the burner of the stenter setting machine, we must ensure that no damage is caused to the fabric in any process. In other words, the integrity of the guide cloth should be ensured, and it should be ensured that it meets the processing requirements. If the guide cloth is found to be stained or damaged, it should be sorted out in time, and if it needs to be replaced, relevant records should be made. In addition, the staff should also check the connection of the power cord and socket of the burner of the stenter setting machine in advance. If anyone finds any damage, they should replace it in time to prevent accidents. If you are interested in low temperature burners, please contact us for a quote!