How to solve the large amount of smoke that is suddenly emitted after the burner is on fire

To After ignition, the burner can be normal, but the strong flame smoke will release the chimney to avoid accidents. After the power was turned off, about half a minute later, a large amount of black smoke suddenly emitted and then detonated. This time, although the tape recorder has stopped working, there is still fire and smoke in the furnace. Remove the burner. The bottom of the heat exchanger collects the diesel oil layer and burns slowly. At first, the bottom of the heat exchanger before the low-temperature ignition of the diesel engine could not ignite immediately. During normal combustion, the burner suddenly emits a large amount of smoke after a fire. How to solve it? To The flame will ignite less heat and diesel, and a large amount of diesel will burn, causing the above phenomenon. In order to eliminate this failure, thoroughly clean the oil accumulated in the heat exchanger, clean the fuel injector, and restore the maintenance control circuit to its original control function. The ignition tester adjusts the throttle opening (exhaust gas combustion, colorless). To The reason for the failure is that the maintenance personnel’s burner effect does not understand the three actions (work) of the line control repair, explosion, fuel injection and ignition, and can’t pre-ignite before the strike to clear the accumulated diesel engine; in this process, the controller does not It will stop due to fire caused by unexpected failure. Since the fire is still diesel injection, the heat exchanger is after a large amount of diesel has accumulated. When the temperature of the next ignition heat exchanger rises, the bottom of the diesel fuel will evaporate and explode violently, causing a serious explosion, which is very dangerous. Remind the equipment maintenance personnel that the original design of the maintenance function must maintain the equipment. In principle, the structure of the modified equipment should not be random or wired without understanding the function of each component. Core Tip: To perform low-temperature baking or work in winter, a baking heater is required. Due to long hours of work and fuel (diesel) in winter, it is in a low temperature environment, which is the season of burner failure. The ignition and combustion of the burner is similar to that of a gasoline engine, although it is relatively simple and has its own characteristics. To If you are interested in gas oil burners, please contact us for a quote!