Preparation work for fabric stenter setting machine burners before cloth dropping operation

In the process of operating the burner of the stenter setting machine, the operation and control of the doffing link is one of the important tasks . First of all, we need to make relevant preparations before performing the cloth dropping operation. Do you know what the preparatory work includes? Let us take a look at the specific content below, I hope it can help everyone! Step, we need to clean the surface of the burner equipment of the stenter setting machine, the work surface, etc., especially the drop frame and the back half of the machine. After that, it is necessary to clean up the work site to ensure the avoidance and cleanliness around the equipment. In the second step, we need to pay attention to check whether the rear part of the equipment is normal, and check whether the auxiliary facilities such as the cloth stacker are complete and intact, whether the cloth guiding and threading route is set reasonably, and whether it can meet the work requirements. After checking and confirming that there are no abnormal problems, the third step is to understand the relevant information and requirements in advance, so as to grasp the process and quality requirements of the fabric to be processed. The textile low-temperature burner is also for the later operation of the stenter setting machine burner Provides convenience. The fourth step is to put the cloth guide car in a suitable position, generally placed under the cloth drop frame, and prepare an empty car to receive the processed cloth produced. In the fifth step, we should choose a suitable empty roll rack according to the specific properties of the fabric to be processed and production requirements. Afterwards, the position layout should be adjusted appropriately to ensure that the winding roller and the cloth roller are parallel. After that, the staff can turn on the burner of the stenter setting machine at the same time to start the setting operation. The above is mainly for you to share the preparation work content of the stenter setting machine burner equipment falling link. I hope that through this sharing, you can deepen your understanding and help you complete the falling operation well. ! If you are interested in low temperature burners, please contact us for a quote!