Talk about the role of some parts in the burner of the stenter setting machine

We know that during the operation of the burner of the stenter setting machine, three important process requirements need to be reasonably controlled, namely temperature , Time and pressure. In the stenter drying room, if it is found that the insulation layer of the drying room needs to be replaced or scrapped, the insulation material filled in the gas low-temperature burner should be treated or destroyed in accordance with relevant local environmental protection regulations. As for the temperature control of the drying room, the process temperature is mainly set by the up and down keys on the temperature control table. Corresponding burners are also provided in the stenter drying room of the burner equipment of the stenter setting machine, which mainly play the role of heating the drying room. The temperature control instrument controls the flame size to control the temperature. The textile burner contactor control logic starts and stops. The operating steps for the burner are: first turn on the circulation fan, then turn on the burner's key switch to allow the burner to work; turn on the main engine and keep the vehicle speed above 5m/min; then set the process temperature on the temperature control table. The burner is finished. The next step is to enter the air-cooling link of the cloth, which is mainly to achieve the requirement of rapid cooling of the fabric. In the tail box of the burner equipment of the stenter setting machine, the main operations include: adjust the needle release position, put down the roll when the cloth is drawn through the tail of the machine, and set the process on the man-machine interface. Parameters (host speed); turn on the host and run the cloth rolling car at the end of the machine; check the lubricating oil quality and quantity of the main engine transmission box according to the regulations, and lubricate the tail motor screw according to the regulations. It should be noted that at the end of the work, the on-site staff should appropriately adjust the tail nut of the cloth outlet cylinder at the tail of the burner of the stenter setting machine to keep the upper roll in the separated position. The main function of surface winding is to roll the finished fabric, and the suitable speed is 2-20m/min. When the burner of the stenter setting machine is rewinding, it can be carried out in different ways, such as manual, stopped, and automatic. In manual mode, the vehicle speed is not controlled by the line speed of the main machine, and the operator can set the speed arbitrarily; in automatic mode, the line speed is slightly faster than the main machine, and the tension of the cloth surface can be adjusted by adjusting the winding speed. When stopped, the winding stops. ! If you are interested in low temperature burners, please contact us for a quote!